CO2 vs N2

By |2019-08-18T19:54:19+00:00May 15th, 2019|Categories: MuCell, TecoCell, Trexel|

Background: The initial development work on microcellular foaming was done using a batch process.  In this process, a plastic part is placed in a high pressure chamber and the chamber is filled with a supercritical fluid (shown in the figure below).  The sample is typically left in the chamber sufficient time, normally in excess of 24 [...]

MuCell performance with Long Glass Fiber Material

By |2019-08-18T19:52:36+00:00May 15th, 2019|Categories: MuCell, TecoCell, Trexel|

Evaluating the Effect of the MuCell Process on Components Made of Long Glass Fiber Polypropylene Materials Summary: The purpose of this study is to address the question about the relevant effect of the MuCell Process on the impact properties of a long glass fiber molded component such as a door module. The testing technique chosen [...]

Chemical vs Physical Foaming

By |2019-08-18T19:53:12+00:00October 9th, 2018|Categories: MuCell, TecoCell, Trexel|

The Foaming Market: The foam injection molding market can be separated into high pressure foam molding and low pressure foam molding.  In general low pressure foam molding is considered to be the structural foam market. This market is defined by parts with relatively thick wall sections, 6 mm and thicker, and machine designed with large [...]